How to setup a 1-column Thumbnail view?

General discussion of the use of FontExpert font manager
Post Reply
Posts: 2
Joined: Tue Dec 27, 2011 4:40 pm

How to setup a 1-column Thumbnail view?

Post by pstein » Wed Dec 28, 2011 1:25 pm

If I go after installation to the "main" Thunbnail view then all the fonts are grouped in three columns.

How can I switch to a 1-column view.

This way I could see the full length of the specified sample text.

Furthermore I would appreciate if the font file name could be put AFTER the font name e.g.

Angsana New Bold [angsab.ttf]

This way the line height resp the gap between the different, subsequent fonts could be smaller and users can view more Fonts at he same time

Is there an option to adjust the view accordingly?


Site Admin
Posts: 306
Joined: Thu Feb 10, 2005 10:20 am
Location: Proxima Software

Re: How to setup a 1-column Thumbnail view?

Post by admin » Thu Jan 05, 2012 2:21 pm

In version 11.0 (and 10.0) you should enlarge width of thumbnail items so that it is slightly less than the width of the view. In this case all thumbnails will be displayed in 1 column. But the file name will be displayed under thumbnails.
To change width of thumbnails:
in version 10.0: use corresponding slider on the toolbar in the Main view.
in version 11.0: use "Width:" slider on the "Font Sample" panel bar (on top of the Main view).

Post Reply